When FortiAnalyzer logging is configured using an FQDN domain, the GUI displays a 500 error message on the FortiView Compromised Hosts page.

Antivirus archive logging enabled from the CLI will be disabled by editing the antivirus profile in the GUI, even if no changes are made.

Inconsistent reference count when using ports in HA session-sync-dev.

When creating an antispam block/allowlist entry, Mark as Reject should be grayed out.

Log viewer forwarded traffic does not support multiple filters for one field.

OK button missing from many pages when viewed in Chrome on an Android device.

VPN event logs are incorrectly filtered when there are two Action filters and one of them contains "-".

Warning message is not displayed when a user configures an interface with a static IP address that is already in use.

Managed FortiSwitch and FortiSwitch Ports pages are slow to load when there are many managed FortiSwitches. This performance issue needs a fix on both FortiOS and FortiSwitch. A fix was provided in FortiOS 7.0.1 GA and FortiSwitch 7.0.1 GA.

When creating or editing an IPv4 policy or address group, firewall address searching does not work if there is an empty wildcard address due to a configuration error.

GUI incorrectly displays the warning, Botnet package update unavailable, AntiVirus subscription not found., when the antivirus entitlement is expiring within 30 days. The actual botnet package update still works within the active entitlement duration.

After performing a search on firewall Addresses, the matched count over total count displayed for each address type shows an incorrect total count number. The search functionality still works correctly.

On Firewall Policy list, the tooltip for IP Pool incorrectly shows Port Block Allocation as being exhausted if there are expiring PBAs available to be reallocated.

The Edit Web Filter Profile page incorrectly shows that a URL filter is configured (even though it is not) if the URL filter entry has the same name as the web filter profile in the CLI.

IPS engine 5.00027 has signal 11 crash.

IPS intelligent mode not working when reflect sessions are created on different physical interfaces.

IPS engine 5.00035 has signal 11 crash.

For API user tokens with CORS enabled and set to wildcard *, direct API requests using this token are not processed properly. This issue impacts FortiOS version 5.6.1 and later.

Workaround: set CORS to an explicit domain.

GUI should add support to allow using switch VLAN interface under a tenant VDOM on a managed switch VDOM.

EHP drops for units with no NP service module.

FortiManager Cloud cannot be removed once the FortiGate has trouble with contract.

There is duplicate information when checking interface references in global.

SNMP does not provide routing table for non-management VDOM.

Interface emac-vlan feature does not work on SoC4 platform.

VXLAN VNI interface cannot be used with a hardware switch.

FortiExtender status becomes discovered after upgrading from 6.0.10 (build 0365).

Workaround: change the admin from discovered to enable after upgrading.

config extender-controller extender
    edit <id>
        set admin enable
    next
end

FG-VM image unable to be deployed on AWS with additional HDD (st1) disk type.

Azure SDN connector replicates configuration from primary device to secondary device during configuration restore.

FG-VM-GCP reboots a couple of times due to kernel panic.

IPsec VPN tunnel not staying up after failing over with AWS A-P cross-AZ setup.

FortiGate AWS bootstrapped from configuration does not read SAML settings.

During every FortiGuard UTM update, there is high CPU usage because only one vCPU is available.