config router multicast6
Description: Configure IPv6 multicast.
set multicast-routing [enable|disable]
set multicast-pmtu [enable|disable]
config interface
Description: Protocol Independent Multicast (PIM) interfaces.
edit <name>
set hello-interval {integer}
set hello-holdtime {integer}
next
end
config pim-sm-global
Description: PIM sparse-mode global settings.
set register-rate-limit {integer}
config rp-address
Description: Statically configured RP addresses.
edit <id>
set ip6-address {ipv6-address}
next
end
end
end| Parameter Name | Description | Type | Size |
|---|---|---|---|
| multicast-routing | Enable/disable IPv6 multicast routing. enable: Enable IPv6 multicast routing. disable: Disable IPv6 multicast routing. |
option | - |
| multicast-pmtu | Enable/disable PMTU for IPv6 multicast. enable: Enable PMTU for IPv6 multicast. disable: Disable PMTU for IPv6 multicast. |
option | - |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| hello-interval | Interval between sending PIM hello messages (1 - 65535 sec, default = 30).. | integer | Minimum value: 1 Maximum value: 65535 |
| hello-holdtime | Time before old neighbour information expires (1 - 65535 sec, default = 105). | integer | Minimum value: 1 Maximum value: 65535 |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| register-rate-limit | Limit of packets/sec per source registered through this RP (0 means unlimited). | integer | Minimum value: 0 Maximum value: 65535 |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| ip6-address | RP router IPv6 address. | ipv6-address | Not Specified |
config router multicast6
Description: Configure IPv6 multicast.
set multicast-routing [enable|disable]
set multicast-pmtu [enable|disable]
config interface
Description: Protocol Independent Multicast (PIM) interfaces.
edit <name>
set hello-interval {integer}
set hello-holdtime {integer}
next
end
config pim-sm-global
Description: PIM sparse-mode global settings.
set register-rate-limit {integer}
config rp-address
Description: Statically configured RP addresses.
edit <id>
set ip6-address {ipv6-address}
next
end
end
end| Parameter Name | Description | Type | Size |
|---|---|---|---|
| multicast-routing | Enable/disable IPv6 multicast routing. enable: Enable IPv6 multicast routing. disable: Disable IPv6 multicast routing. |
option | - |
| multicast-pmtu | Enable/disable PMTU for IPv6 multicast. enable: Enable PMTU for IPv6 multicast. disable: Disable PMTU for IPv6 multicast. |
option | - |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| hello-interval | Interval between sending PIM hello messages (1 - 65535 sec, default = 30).. | integer | Minimum value: 1 Maximum value: 65535 |
| hello-holdtime | Time before old neighbour information expires (1 - 65535 sec, default = 105). | integer | Minimum value: 1 Maximum value: 65535 |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| register-rate-limit | Limit of packets/sec per source registered through this RP (0 means unlimited). | integer | Minimum value: 0 Maximum value: 65535 |
| Parameter Name | Description | Type | Size |
|---|---|---|---|
| ip6-address | RP router IPv6 address. | ipv6-address | Not Specified |