Route leaking between VRFs with BGP

Route leaking allows you to configure communication between VRFs. If route leaking is not configured, then the VRFs are isolated. This example shows route leaking with BGP using virtual inter-VDOM links.

In this example, a hub FortiGate forms BGP neighbors with two branches. It learns the networks 192.168.101.0/24 and 192.168.102.0/24 from the neighbors and separates them into VRF 10 and VRF 20.

To leak the learned routes to each other, an inter-VDOM link (IVL) is formed. An IVL normally bridges two VDOMs, but in this case the links reside on the same VDOM and are used to bridge the two VRFs. NPU links could also be used on models that support it to deliver better performance.

VRF 10 has a leaked route to 192.168.102.0/24 on IVL link-10-20-0, and VRF 20 has a leaked route to 192.168.101.0/24 on IVL link-10-20-1,

To configure route leaking:

1. Allow interface subnets to use overlapping IP addresses:

   config system settings
       set allow-subnet-overlap enable
   end

2. Configure the inter-VDOM links:

   config system vdom-link
       edit link-10-20-
       next
   end

3. Configure the interface settings:

   config system interface
       edit link-10-20-0
           set vdom "root"
           set vrf 10
           set ip 10.1.1.1/30
       next
       edit link-10-20-1
           set vdom "root"
           set vrf 20
           set ip 10.1.1.2/30
       next
   end

4. Create the prefix lists:

   These objects define the subnet and mask that are leaked.

   config router prefix-list
       edit VRF10_Route
           config rule
               edit 1
                   set prefix 192.168.101.0 255.255.255.0
               next
           end
       next
       edit VRF20_Route
           config rule
               edit 1
                   set prefix 192.168.102.0 255.255.255.0
               next
           end
       next
   end

5. Create the route map:

   The route map can be used to group one or more prefix lists.

   config router route-map
       edit "Leak_from_VRF10_to_VRF20"
           config rule
               edit 1
                   set match-ip-address "VRF10_Route"
               next
           end
       next
       edit "Leak_from_VRF20_to_VRF10"
           config rule
               edit 1
                   set match-ip-address "VRF20_Route"
               next
           end
       next
   end

6. Configure the VRF leak in BGP, specifying a source VRF, destination VRF, an the route map to use:

   config router bgp
       config vrf-leak
           edit "10"
               config target
                   edit "20"
                       set route-map "Leak_from_VRF10_to_VRF20"
                       set interface "link-10-20-0"
                   next
               end
           next
           edit "20"
               config target
                   edit "10"
                       set route-map "Leak_from_VRF20_to_VRF10"
                       set interface "link-10-20-1"
                   next
               end
           next
       end
   end

7. Create policies to allow traffic between the VRFs.

   Without a policy permitting traffic on the route between the VRFs, the VRFs are still isolated.