Local-based filters

You can make black or white lists (BWLs) from emails or IP subnets to forbid or allow them to send or receive emails.

You can also define a list of banned words. Emails that contain any of these banned words are considered spam.

With the spamhelodns and spamraddrdns commands, the FortiGate performs a standard DNS check on the machine name used in the helo SMTP message, and/or the return-to field to determine if these names belong to a registered domain. The FortiGate does not check the FortiGuard service during these operations.

To configure a local-based email filter in the CLI:

1. Configure a BWL:

   config emailfilter bwl
       edit 1
           set name "mtBWL"
           config entries
               edit 1
                   set status enable
                   set type ip
                   set action spam
                   set addr-type ipv4
                   set ip4-subnet 10.1.100.0 255.255.255.0
               next
           end
       next
   end

2. Configure an email filter profile:

   config emailfilter profile                                             
       edit "myLocalEmailFilter"
           set spam-filtering enable
           set options spambwl spamhelodns spamraddrdns   		
           config smtp
               set action tag
           end
           set spam-bwl-table 1                                           
       next
   end

3. Use the profile in a firewall policy:

   config firewall policy
       edit 1
           .....
           set inspection-mode proxy                                     	
           set emailfilter-profile "myLocalEmailFilter"                 	
       next
   end

To configure a local-based email filter in the GUI:

1. Go to Security Profiles > Email Filter.
2. Click Create New or select an existing profile and click Edit.

   

3. In the firewall policy, create or edit a rule.
4. Set the inspection-mode to Proxy-based.
5. Enable the Email Filter option and select the previously created profile.

   

6. Set SSL Inspection to a profile that has deep SSL inspection enabled.

   Deep inspection is required if you intend to filter SMTP, POP3, IMAP, or any SSL/TLS encapsulated protocol. The below SSL-inspection profile has deep inspection enabled:

   

7. Click OK.

To configure bannedwords in the CLI:

1. Configure a bannedwords list:

   config emailfilter bword
       edit 1
           set name "banned"
           config entries
               edit 1
                   set pattern "undesired_word"
               next
           end
       next
   end
   

2. Configure an email filter profile:

   config emailfilter profile
       edit "myBannedWordsProfile"
           config file-filter
               set status disable
           end
           set spam-filtering enable
           set options bannedword
           set spam-bword-table 1
       next
   end

3. Use the profile in a firewall policy:

   config firewall policy
       edit 1
           .....
           set inspection-mode proxy                                     	
           set emailfilter-profile "myBannedWordsProfile"                 	
       next
   end

Once created, this profile should be set in the firewall policy.

Bannedwords can only be configured through the CLI.