SNMP Link Traps (FortiOS 6.2.1 and above)

Note: If Syslog is already configured, do not configure SNMP traps and proceed to Configure FortiNAC.

In the FortiSwitch CLI, set the system interface to allow SNMP via the FortiGate. For FortiSwitch CLI access instructions, see Appendix.

Reference:

https://docs.fortinet.com/document/fortiswitch/7.0.4/fortiswitchos-cli-reference/500379/config-system#config16

https://docs.fortinet.com/document/fortiswitch/6.4.3/fortiswitchos-cli-reference/500379/config-system#config16

Type the following commands

config system interface

edit "internal"

set mode dhcp

set allowaccess ping https ssh snmp

set type physical

set snmp-index 30

set defaultgw enable

next

end

Example:

FSW-Corp-Eng-01 (internal) # show

config system interface

edit "internal"

set mode dhcp

set allowaccess ping https ssh snmp

set type physical

set snmp-index 30

set defaultgw enable

next

end

Proceed to Configure FortiNAC (Link Mode).