Procedure

General Steps

1. Configure SNMP MAC Notification traps on all access ports (see requirements above).

2. Remove linkUp and linkDown traps on ports where Mac Notification traps are added.

3. Configure SNMP and enable MAC Notification traps pointed to the FortiNAC eth0 IP address.

4. Configure MAC address table notifications globally.

5. Configure Context settings in switch for reading Mib-2 information. Note: This step only applies to certain devices managed using SNMP v3.

The following pages provide configuration examples for supported switches:

Alcatel

Cisco cat4500e

Cisco 3560

Dell

Extreme

HP

H3C / HPE

Juniper

Ruckus Brocade

Note: Based on switch model or version, some of the commands may vary. It is recommended to review any associated vendor product documentation.