Connecting to individual FPC CLIs

From the management board CLI you can use the following command to log into the CLI of individual FPCs:

execute load-balance slot manage {<chassis>.slot | slot}

Where:

<slot> is the slot number of the component that you want to log in to. The management board is in slot 0 and the FPC slot numbers start at 1. In an FGCP HA cluster you must also include the <chassis> number which can be 1 or 2.

When connected to the CLI of a FPC, you can view information about the status or configuration of the FPC, restart the FPC, or perform other operations. You should not change the configuration of individual FPCs because this can cause configuration synchronization errors.

Use the exit command to end the session and return to the CLI from which you ran the original command.