Interface management
FortiExtender-40D-AMEU comes with one LAN interface and one LTE interface, whereas FortiExtender-201E comes with one WAN interface, one LTE interface, and four LAN interfaces. The table below describes the CLI commands used to configure the system interface.
CLI command |
Description |
---|---|
config system interface |
Enters system interface configuration mode. |
edit <interface_name> |
Specify or edit an interface name. |
set type <type> |
Select the interface type:
|
set status {up | down} |
Specify the interface state:
|
set mode {static | dhcp} |
Set the interface IP addressing mode:
|
set ip <ip> |
(Applicable only when IP addressing mode is set to "static".) Specify an IPv4 address and subnet mask in the format: |
set gateway <gateway> |
Set an IPv4 address for the router in the format: |
set mtu <mtu> |
Set the interface's MTU value in the range of 0–4294967295. |
allowaccess {ping | http | https | telnet | capwap} |
Select the types of management traffic allowed to access the interface:
|