Fortinet black logo

Handbook

Replacement Messages

Replacement Messages

From the System > Replacement Messages sub-menu, you can configure the pre-login disclaimer message that shows before the user reaches the login page.

The Pre-login disclaimer message configuration is not supported when FortiADC is in SSLi mode.

To configure the pre-login disclaimer in the GUI:
  1. Go to System > Replacement Messages.
  2. In the Pre-login Disclaimer Message tab, edit the message.
  3. Click Save.

Enable the pre-login banner

The pre-login banner needs to be enabled to show the pre-login disclaimer messages.

To enable the pre-login banner in the GUI:
  1. Go to System > Settings.
  2. In the Basic tab, enable Pre Login Banner.
  3. Click Save.
To enable the pre-login banner in the CLI:

config system global

set pre-login-banner enable

end

Replacement Messages

From the System > Replacement Messages sub-menu, you can configure the pre-login disclaimer message that shows before the user reaches the login page.

The Pre-login disclaimer message configuration is not supported when FortiADC is in SSLi mode.

To configure the pre-login disclaimer in the GUI:
  1. Go to System > Replacement Messages.
  2. In the Pre-login Disclaimer Message tab, edit the message.
  3. Click Save.

Enable the pre-login banner

The pre-login banner needs to be enabled to show the pre-login disclaimer messages.

To enable the pre-login banner in the GUI:
  1. Go to System > Settings.
  2. In the Basic tab, enable Pre Login Banner.
  3. Click Save.
To enable the pre-login banner in the CLI:

config system global

set pre-login-banner enable

end