Configuring an IPv4 prefix list
FortiADC supports IPv4 prefix lists over BGP routing. If you are configuring BGP routing using IPv4, you must configure prefix lists using the IPv4 protocol.
To configure an IPv4 prefix list:
- Go to Network > Routing.
- Click the Prefix List tab.
- Click Create New to display the configuration editor.
- Configure the following Prefix List settings:
Setting
Guideline
Name Enter a unique name for the new access list.
The name can be up to 35 alphanumeric characters long, including
.
(period) ,:
(colon),_
(underscore), and-
(hyphen). No space is allowed.Description Optionally, enter a brief description of the access list.
The description can be up to 1023 alphanumeric characters long, with no restriction on use of special characters. Space between characters is allowed.
- Click Save.
Once the Prefix List configuration is saved, the Rule will be available to configure. - In the Rule section, click Create New to display the configuration editor.
- Configure the following Prefix List Rule settings:
Setting
Guideline
Action Select the action as Permit or Deny. IPv4 Prefix Enter the IPv4 address/subnet mask in the format of 0.0.0.0./0. GE
Specify the GE (greater than and equal to) values. Set to 0 or a number larger than netmask.
LE
Specify the LE (less than and equal to) values. Set to 0 or a number no smaller than GE.
- Click Save.
The dialog closes once the Rule configuration is saved. - Click Save to update the Prefix List configuration.