Fortinet Document Library

Version:

Version:


Table of Contents

VM on VMware

Download PDF
Copy Link

Enabling GUI access

To enable GUI access to the FortiDeceptor VM, you must configure the port1 IP address and network mask of the FortiDeceptor VM.

To configure the port1 IP address and netmask:
  1. In your hypervisor manager, start the FortiDeceptor VM and access the console window. You might need to press Enter to see the login prompt.
  2. At the FortiDeceptor VM login prompt, enter the username admin, then press Enter. By default, there is no password.
  3. Configure the port1 IP address and netmask by using the following command:
  4. set port1-ip <ip address>/<netmask>

  5. Configure the static route for the default gateway by using the following command:
  6. set default-gw <default gateway>

    The Customer Service & Support portal does not currently support IPv6 for FortiDeceptor VM license validation. You must specify an IPv4 address in both the support portal and the port management interface.

Enabling GUI access

To enable GUI access to the FortiDeceptor VM, you must configure the port1 IP address and network mask of the FortiDeceptor VM.

To configure the port1 IP address and netmask:
  1. In your hypervisor manager, start the FortiDeceptor VM and access the console window. You might need to press Enter to see the login prompt.
  2. At the FortiDeceptor VM login prompt, enter the username admin, then press Enter. By default, there is no password.
  3. Configure the port1 IP address and netmask by using the following command:
  4. set port1-ip <ip address>/<netmask>

  5. Configure the static route for the default gateway by using the following command:
  6. set default-gw <default gateway>

    The Customer Service & Support portal does not currently support IPv6 for FortiDeceptor VM license validation. You must specify an IPv4 address in both the support portal and the port management interface.