Enabling GUI access
To configure the port1 IP address and netmask:
- In your hypervisor manager, start the FortiDeceptor VM and access the console window. You might need to press Enter to see the login prompt.
- At the FortiDeceptor VM login prompt, enter the username admin, then press Enter. By default, there is no password.
- Configure the port1 IP address and netmask by using the following command:
- Configure the static route for the default gateway by using the following command:
set port1-ip <ip address>/<netmask>
set default-gw <default gateway>
The Customer Service & Support portal does not currently support IPv6 for FortiDeceptor VM license validation. You must specify an IPv4 address in both the support portal and the port management interface.