Fortinet black logo

CLI Reference

create-raid rebuild

create-raid rebuild

Use the this command to rebuild the RAID.

Currently, only RAID level 1 is supported, and only on FortiWeb-1000B, 1000C, 3000C/CFsx, 3000E, and 4000E shipped with FortiWeb 4.0 MR1 or later.

On older appliances that have been upgraded to FortiWeb 4.0 MR1, RAID cannot be activated.

Back up the data regularly. RAID is not a substitute for regular backups. RAID 1 (mirroring) is designed to improve hardware fault tolerance, but cannot negate all risks.

Rebuilding the array due to disk failure may result in some loss of packet log data.

To use this command, your administrator account’s access control profile must have either w or rw permission to the sysgrp area. For details, see Permissions.

Syntax

execute create-raid rebuild

Example

This example rebuilds the RAID array.

execute create-raid rebuild


The CLI displays the following:

This operation will clear all data on disk :0!

Do you want to continue? (y/n)


After you enter y (yes), the CLI displays additional messages.

Related topics

create-raid rebuild

create-raid rebuild

Use the this command to rebuild the RAID.

Currently, only RAID level 1 is supported, and only on FortiWeb-1000B, 1000C, 3000C/CFsx, 3000E, and 4000E shipped with FortiWeb 4.0 MR1 or later.

On older appliances that have been upgraded to FortiWeb 4.0 MR1, RAID cannot be activated.

Back up the data regularly. RAID is not a substitute for regular backups. RAID 1 (mirroring) is designed to improve hardware fault tolerance, but cannot negate all risks.

Rebuilding the array due to disk failure may result in some loss of packet log data.

To use this command, your administrator account’s access control profile must have either w or rw permission to the sysgrp area. For details, see Permissions.

Syntax

execute create-raid rebuild

Example

This example rebuilds the RAID array.

execute create-raid rebuild


The CLI displays the following:

This operation will clear all data on disk :0!

Do you want to continue? (y/n)


After you enter y (yes), the CLI displays additional messages.

Related topics