system firewall address
Use this command to configure IP addresses and address ranges that FortiWeb's built-in stateful firewall uses. You use the address configuration in a firewall policy. For details, see system firewall firewall-policy.
Syntax
config system firewall address
edit "<firewall-address_name>"
set type {ip-netmask | ip-range}
set ip-netmask "<firewall-address_ipv4mask>"
set ip-address-value "<firewall-address_ipv4>"
end
| Variable | Description | Default |
| Enter a name that identifies this firewall address configuration. | No default. | |
|
Select how this configuration specifies a firewall address or addresses:
|
ip-range
|
|
|
Enter an IPv4 address and subnet mask, separated by a forward slash ( / ). For example, |
No default. | |
Enter a single IP address or a range of addresses. For example, 192.0.2.1, or 192.0.2.1-192.0.2.256.Available when type {ip-netmask | ip-range} is ip-range. |
No default. |