Use this command to display a list of hard disks and their capacity in megabytes (MB) in the FortiWeb appliance. In the case of FortiWeb-VM, this will instead be for virtual hardware.
To use this command, your administrator account’s access control profile must have at least
r permission to the
sysgrp area. For details, see Permissions.
diagnose hardware harddisk [list]
diagnose hardware harddisk list
Output similar to the following appears in the CLI:
On a FortiWeb 1000C with a single properly functioning internal hard disk plus its internal flash disk, this command should show two file systems:
sda, the larger file system, is from the hard disk used to store non-configuration/firmware data. If it does not appear, you can reboot and attempt to run a file system check to fix the file system and mount it.
Similarly FortiWeb 3000D shows: