Configuring SIP settings
The FortiVoice Gateway supports SIP communications.
To configure SIP settings
- Go to System > Advanced Setting > SIP.
- Configure the following fields:
GUI field
Description
SIP Transport and Internal Ports
Enable and enter the ports, as required.
SIP communication commonly uses TCP or UDP port 5060 and/or 5061.
Port 5060 is used for nonencrypted SIP signaling sessions.
Port 5061 is typically used for SIP sessions encrypted with Transport Layer Security (TLS).
The WebSocket Secure (WSS) protocol establishes a WebSocket over an encrypted TLS connection. The default port is 8089.
RTP Setting
Port
Enter the start and end RTP ports that the FortiVoice Gateway will use for phone call sessions.
Make sure that there is a reasonable port range so that you have enough ports for all open calls. The default port range is 10000 to 30000.
RTP timeout
Enter the amount of time in seconds during an active call that the extension will wait for RTP packets before hanging up the call. A value of 0 (zero) means there is no time limit. The default is 7200.
RTP hold timeout
Enter the amount of time in seconds that the extension will wait on hold for RTP packets before hanging up the call. A value of 0 (zero) means there is no time limit. The default is 7200.
- Click Apply.