LLDP and Manual VLAN Technical Note
Configure gate and manual VLAN trunks
Configure gate and manual VLAN trunks
- On FortiSwitch, go to Switch > Port > Trunk and create the following four static trunks:
- One on port 1 (Gate-trunk)
- Three on the remaining ports 2, 3, and 4 (Manual-Trunk-Portx)
- Go to Switch > Interface > Trunk and configure the trunk's native and allowable VLAN settings:
- Set the Native VLAN for each trunk to 1.
- Assign each trunk the native, voice, and data VLAN (1, 100, and 200).
Configure gate and manual VLAN trunks
- On FortiSwitch, go to Switch > Port > Trunk and create the following four static trunks:
- One on port 1 (Gate-trunk)
- Three on the remaining ports 2, 3, and 4 (Manual-Trunk-Portx)
- Go to Switch > Interface > Trunk and configure the trunk's native and allowable VLAN settings:
- Set the Native VLAN for each trunk to 1.
- Assign each trunk the native, voice, and data VLAN (1, 100, and 200).