Fortinet black logo

Administration Guide

Layer-2 table

Copy Link
Copy Doc ID f65c09ce-240d-11ed-9eba-fa163e15d75b:287003
Download PDF

Layer-2 table

FortiSwitchOS uses the layer-2 table to store static MAC addresses and dynamic MAC addresses. Starting in FortiSwitchOS 7.0.0, you can use the CLI to control whether the size of the layer-2 table is checked and how often. By default, this feature is disabled. When you enable this feature, two checks are performed for each platform:

  • The first time that the layer-2 table size is more than 75-percent full for each platform, FortiSwitchOS adds a warning to the system log.
  • The first time that the layer-2 table size is less than 70-percent full for each platform, FortiSwitchOS adds a warning to the system log.

When you enable this feature, FortiSwitchOS checks the layer-2 table every 2 minutes. You can change how often the layer-2 table is checked to 5-86,400 seconds.

To enable this feature and specify the interval:

config switch global

set l2-memory-check enable

set l2-memory-check-interval <number_of_seconds>

end

For example:

config switch global

set l2-memory-check enable

set l2-memory-check-interval 1000

end

To disable this feature:

config switch global

set l2-memory-check disable

end

Layer-2 table

FortiSwitchOS uses the layer-2 table to store static MAC addresses and dynamic MAC addresses. Starting in FortiSwitchOS 7.0.0, you can use the CLI to control whether the size of the layer-2 table is checked and how often. By default, this feature is disabled. When you enable this feature, two checks are performed for each platform:

  • The first time that the layer-2 table size is more than 75-percent full for each platform, FortiSwitchOS adds a warning to the system log.
  • The first time that the layer-2 table size is less than 70-percent full for each platform, FortiSwitchOS adds a warning to the system log.

When you enable this feature, FortiSwitchOS checks the layer-2 table every 2 minutes. You can change how often the layer-2 table is checked to 5-86,400 seconds.

To enable this feature and specify the interval:

config switch global

set l2-memory-check enable

set l2-memory-check-interval <number_of_seconds>

end

For example:

config switch global

set l2-memory-check enable

set l2-memory-check-interval 1000

end

To disable this feature:

config switch global

set l2-memory-check disable

end