Fortinet Document Library
Version:
7.0.4
7.0.2
7.0.1
Version:
7.0.0
6.4.5
6.4.3
Version:
6.4.2
6.4.0
6.2.3
Version:
6.2.2
6.2.1
6.2.0
Version:
6.0.4
6.0.3
6.0.1
Version:
6.0.0
6.0.0
3.6.3
Version:
3.6.0
3.5.4
Table of Contents
Whatʼs new in FortiOS 7.0.4
Introduction
Special notices
FortiSwitch management
Configuring FortiLink
Optional FortiLink configuration required before discovering and authorizing FortiSwitch units
Discovering
Optional FortiLink configuration
Disabling stacking
Determining the network topology
Single FortiGate managing a single FortiSwitch unit
Single FortiGate unit managing a stack of several FortiSwitch units
HA-mode FortiGate units managing a single FortiSwitch unit
HA-mode FortiGate units managing a stack of several FortiSwitch units
HA-mode FortiGate units managing a FortiSwitch two-tier topology
Single FortiGate unit managing multiple FortiSwitch units (using a hardware or software switch interface)
HA-mode FortiGate units using hardware-switch interfaces and STP
FortiLink over a point-to-point layer-2 network
FortiLink mode over a layer-3 network
Switch redundancy with MCLAG
MCLAG peer groups
MCLAG requirements
Transitioning from a FortiLink split interface to a FortiLink MCLAG
Deploying MCLAG topologies
Configuring FortiSwitch VLANs and ports
Configuring VLANs
Configuring ports using the GUI
Configuring port speed and status
Configuring PoE
Adding 802.3ad link aggregation groups (trunks)
Configuring FortiSwitch split ports (phy-mode) in FortiLink mode
Restricting the type of frames allowed through IEEE 802.1Q ports
Multitenancy and VDOMs
Configuring switching features
Configuring DHCP blocking, STP, and loop guard on managed FortiSwitch ports
Configuring edge ports
Configuring loop guard
Configuring STP settings
Dynamic MAC address learning
Configuring storm control
Configuring IGMP-snooping settings
Configuring PTP transparent-clock mode
Device detection
Enabling network-assisted device detection
Voice device detection
Configuring IoT detection
Configuring LLDP-MED settings
FortiSwitch security
FortiSwitch network access control
Configuring dynamic port policy rules
FortiSwitch security policies
Configuring the DHCP trust setting
Configuring the DHCP server access list
Configuring dynamic ARP inspection (DAI)
Configuring IPv4 source guard
Security Fabric showing
Blocking intra-VLAN traffic
Quarantines
Optimizing the FortiSwitch network
Configuring QoS with managed FortiSwitch units
Configuring ECN for managed FortiSwitch devices
Logging and monitoring
FortiSwitch log settings
Configuring FortiSwitch port mirroring
Configuring SNMP
Configuring sFlow
Configuring flow tracking and export
Configuring flow control and ingress pause metering
Operation and maintenance
Discovering, authorizing, and deauthorizing FortiSwitch units
Managed FortiSwitch display
Diagnostics and tools
FortiSwitch ports display
FortiSwitch per-port device visibility
Managing DSL transceivers (FN-TRAN-DSL)
Displaying, resetting, and restoring port statistics
Network interface display
Data statistics
Synchronizing the FortiGate unit with the managed FortiSwitch units
Viewing and upgrading the FortiSwitch firmware version
Canceling pending or downloading FortiSwitch upgrades
Registering FortiSwitch to FortiCloud
Replacing a managed FortiSwitch unit
Executing custom FortiSwitch scripts
Resetting PoE-enabled ports
Home
FortiSwitch 7.0.4
Devices Managed by FortiOS
Devices Managed by FortiOS
Whatʼs new in FortiOS 7.0.4
Introduction
Special notices
FortiSwitch management
Configuring FortiLink
Optional FortiLink configuration required before discovering and authorizing FortiSwitch units
Discovering
Optional FortiLink configuration
Disabling stacking
Determining the network topology
Single FortiGate managing a single FortiSwitch unit
Single FortiGate unit managing a stack of several FortiSwitch units
HA-mode FortiGate units managing a single FortiSwitch unit
HA-mode FortiGate units managing a stack of several FortiSwitch units
HA-mode FortiGate units managing a FortiSwitch two-tier topology
Single FortiGate unit managing multiple FortiSwitch units (using a hardware or software switch interface)
HA-mode FortiGate units using hardware-switch interfaces and STP
FortiLink over a point-to-point layer-2 network
FortiLink mode over a layer-3 network
Switch redundancy with MCLAG
MCLAG peer groups
MCLAG requirements
Transitioning from a FortiLink split interface to a FortiLink MCLAG
Deploying MCLAG topologies
Configuring FortiSwitch VLANs and ports
Configuring VLANs
Configuring ports using the GUI
Configuring port speed and status
Configuring PoE
Adding 802.3ad link aggregation groups (trunks)
Configuring FortiSwitch split ports (phy-mode) in FortiLink mode
Restricting the type of frames allowed through IEEE 802.1Q ports
Multitenancy and VDOMs
Configuring switching features
Configuring DHCP blocking, STP, and loop guard on managed FortiSwitch ports
Configuring edge ports
Configuring loop guard
Configuring STP settings
Dynamic MAC address learning
Configuring storm control
Configuring IGMP-snooping settings
Configuring PTP transparent-clock mode
Device detection
Enabling network-assisted device detection
Voice device detection
Configuring IoT detection
Configuring LLDP-MED settings
FortiSwitch security
FortiSwitch network access control
Configuring dynamic port policy rules
FortiSwitch security policies
Configuring the DHCP trust setting
Configuring the DHCP server access list
Configuring dynamic ARP inspection (DAI)
Configuring IPv4 source guard
Security Fabric showing
Blocking intra-VLAN traffic
Quarantines
Optimizing the FortiSwitch network
Configuring QoS with managed FortiSwitch units
Configuring ECN for managed FortiSwitch devices
Logging and monitoring
FortiSwitch log settings
Configuring FortiSwitch port mirroring
Configuring SNMP
Configuring sFlow
Configuring flow tracking and export
Configuring flow control and ingress pause metering
Operation and maintenance
Discovering, authorizing, and deauthorizing FortiSwitch units
Managed FortiSwitch display
Diagnostics and tools
FortiSwitch ports display
FortiSwitch per-port device visibility
Managing DSL transceivers (FN-TRAN-DSL)
Displaying, resetting, and restoring port statistics
Network interface display
Data statistics
Synchronizing the FortiGate unit with the managed FortiSwitch units
Viewing and upgrading the FortiSwitch firmware version
Canceling pending or downloading FortiSwitch upgrades
Registering FortiSwitch to FortiCloud
Replacing a managed FortiSwitch unit
Executing custom FortiSwitch scripts
Resetting PoE-enabled ports
7.0.4
7.0.4
7.0.2
7.0.1
7.0.0
6.4.5
6.4.3
6.4.2
6.4.0
6.2.3
6.2.2
6.2.1
6.2.0
6.0.4
6.0.3
6.0.1
6.0.0
6.0.0
3.6.3
3.6.0
3.5.4
Download PDF
Copy Link
Logging and monitoring
This section covers the following topics:
FortiSwitch log settings
Configuring FortiSwitch port mirroring
Configuring SNMP
Configuring sFlow
Configuring flow tracking and export
Configuring flow control and ingress pause metering
Logging and monitoring
Logging and monitoring
This section covers the following topics:
FortiSwitch log settings
Configuring FortiSwitch port mirroring
Configuring SNMP
Configuring sFlow
Configuring flow tracking and export
Configuring flow control and ingress pause metering
Link
PDF
TOC