Fortinet Document Library

Version:

Version:

Version:

Version:


Table of Contents

Administration Guide

Download PDF
Copy Link

Enabling packet forwarding

NOTE: These commands apply only to the 200 Series and 400 Series.

If you want to use layer-3 interfaces and IGMP snooping on certain FortiSwitch models, you must enable the forwarding of reserved multicast packets and IPv6 neighbor-discovery packets to the CPU. These features are enabled by default.

config switch global

set reserved-mcast-to-cpu {enable | disable}

set neighbor-discovery-to-cpu {enable | disable}

end

Enabling packet forwarding

NOTE: These commands apply only to the 200 Series and 400 Series.

If you want to use layer-3 interfaces and IGMP snooping on certain FortiSwitch models, you must enable the forwarding of reserved multicast packets and IPv6 neighbor-discovery packets to the CPU. These features are enabled by default.

config switch global

set reserved-mcast-to-cpu {enable | disable}

set neighbor-discovery-to-cpu {enable | disable}

end