Starting in FortiSwitchOS 6.4.0, you can run FortiLink mode over a point-to-point layer-2 network. You can form an inter-switch link (ISL) between two FortiSwitch units over a layer-2 device or non-FortiSwitch device (such as a wireless bridge). To create this topology, you configure ports on both ends of the link as described in the following procedure and, optionally, configure the tag protocol identifier (TPID) between the two FortiSwitch units.
set fortilink-p2pcommand is available in FortiLink mode and standalone mode. The
set fortilink-p2p-tpidcommand is available only in FortiLink mode.
- The FS-108E, FS-108E-POE, FS-108E-FPOE, FS-124E, FS-124E-POE, FS-124E-FPOE, FS-148E, FS-148E-POE, FS-148F, FS-148F-POE, FS-148F-FPOE, FS-124F, FS-124F-POE, and FS-124F-FPOE models support only the default 0x8100 TPID; TPID changes are not supported.
- Enable the FortiLink point-to-point network on each FortiSwitch unit:
config switch physical-port
set fortilink-p2p enable
- Make certain that the FortiLink point-to-point TPID value is the same on each FortiSwitch unit. By default, it is 0x8100.
config switch global
set fortilink-p2p-tpid <0x0001-0xfffe>