Main HA-Cluster CLI commands
The table below lists the CLI commands to administer your HA-Cluster.
|
hc-settings |
Configure the unit as a HA-Cluster mode unit. Set or unset cluster failover IP set. |
|
hc-status -l |
List the status of HA-Cluster units. |
|
hc-worker |
|
|
hc-primary -s<10-100> |
Turn on file scan on the primary node with 10% to 100% processing capacity. |
|
hc-primary -r<serial number> |
Remove the worker or secondary unit with the specified serial number from the primary node. |
After removing a worker or secondary node, use hc-status -l on the primary node to verify that the worker or secondary node has been removed.