Enabling GUI access

To enable GUI access to the FortiSandbox you must configure the port1 IP address and network mask of the FortiSandbox.

To configure the port1 IP address and netmask:

1. In your hypervisor manager, start the FortiSandbox and access the console window. You might need to press Enter to see the login prompt.
2. At the FortiSandbox login prompt, enter the username admin, then press Enter. By default, there is no password.
3. Using CLI commands, configure the port1 IP address and netmask with the following command:

   set port1-ip <ip address>/<netmask>

4. Configure the static route for the default gateway with the following command:

   set default-gw <default gateway>

The Customer Service & Support portal does not currently support IPv6 for FortiSandbox license validation. You must specify an IPv4 address in both the support portal and the port management interface.