Configuring the cameras
Cameras can now be configured in FortiRecorder, and routing can be established to the FortiGate HQ.
To set up a camera in FortiRecorder:
- Go to Camera > Configuration > Camera Profile.
- Select an existing camera and select Edit or select New.
- Name the profile and edit the settings as desired.
Edge recording works with either continuous or motion detection. - In the Recording section, enable SD card.
- Select Create.
- Go to System > Network > Routing.
- Select New.
- Enter the DMZ subnet of your branch location where the cameras are located in the Destination IP/netmask field.
- Select the desired interface and enter the gateway.
- Select Create.
- Ping the camera from the recorder.
- Go to Camera > Configuration > Camera.
- Enter the necessary details and select Wired from the address mode dropdown menu.
- Enter the address, select edge-recording from the Profile dropdown menu, and select Create.