Settings

This section describes some additional FortiPresence VM settings. Navigate to Site Management > Settings and select the site. After configuring the settings, click Apply Changes.

• Bounce Time Limit

• Dwell Inactive Time Limit

• Min Count of Observations

• Employees Filter

• Non (OUI) MAC address

• Detect Fixed Assets

Bounce Time Limit

This setting aids in collecting bounce rate analytics, that is, total number of stayed/engaged visitors based on the bounce rate threshold configured. Visitors who spend more time than the configured Bounce Time Limit are classified as stayed and the ones less than the bounce rate as bounced. This visitor statistics is reported in Presence Dashboard under Bounce Rate chart.

Dwell Inactive Time Limit

This setting aids in collecting dwell time analytics, that is, the visitor dwell time based on the Dwell Inactive Time Limit threshold. If a visitor is seen after a gap of the configured threshold, it is considered as a new dwelling session for dwell time calculation. If the visitor is seen within the configured threshold, the dwell session continues. This visitor statistics is reported in Presence Dashboard under Dwell Time chart.

Min Count of Observations

This setting lends accuracy to the visitor data on the dashboards. You can filter out random MAC addresses from devices in and around your establishment by setting the count of observations. Based on this setting visitor is reported only if he is seen more than or equal to Min Count of Observations. Note that the device reporting interval can be set while configuring location services.

Employees Filter

This setting is enabled by default and filters out the employee MAC addresses added in the Employees tab from site level analytics.

Non (OUI) MAC address

When enabled, this setting filters out the non Organizational Unique Identifier (OUI) MAC Addresses and is applicable for all the dashboards.

Detect Fixed Assets

You can specify threshold parameters that determine fixed assets to be excluded from analytics.
The threshold parameters are number of hours and number of days (maximum: 7 days). If a device MAC address is detected for more than the configured number of hours per day for the configured number of (consecutive) days then that device is declared a fixed asset and is excluded from analytics.
For example, if the threshold configuration is 5 hours and 3 days, then any device detected for more than 5 hours per day for a period of 3 consecutive days is declared a fixed asset. To view the fixed assets filtered for the configured threshold, select Auto-Detected Assets in Resources.