Installing FortiPortal 7.4.1

To install FortiPortal 7.4.1:

1. Deploy the VMware FortiPortal image file on a hypervisor.

   Make sure the network interface is connected to a reachable network adapter.

2. Once the FortiPortal instance is booted up, log in with the default username admin and password portal1234.

   You are prompted to change the admin user password immediately.

3. In the CLI console, enter the following commands to configure the IP address for the instance:

   config system interface

   edit port1

   set ip x.x.x.x/x.x.x.x

   end

   If needed, configure additional ports (port2, port3, etc.) in the same manner.

4. In the CLI console, enter the following commands to configure the default route for the instance:

   config system route

   edit 1

   set device port1

   set gateway x.x.x.x

   end

5. Optionally, in the CLI console, enter the following commands to configure the DNS for the instance:

   config system dns

   set primary x.x.x.x

   set secondary y.y.y.y

   end

6. Optionally, in the CLI console, enter the following commands to configure the NTP for the instance:

   config system ntp

   config ntpserver

   edit 1

   set server x.x.x.x or <hostname>

   end

7. Connect to FortiPortal via the web interface using the configured IP address. The default web login username and password are spuser and test12345, respectively. Upon login, you are required to change the web login password.

   The login credentials are separated between web UI and console/SSH.