Preparing FortiManager and FortiAnalyzer

FortiPortal interacts with FortiManager and FortiAnalyzer. For more information, see the FortiPortal Administration Guide. Fortinet also recommends contacting your Fortinet Systems Engineer for assistance.

To configure FortiManager to work with FortiPortal:

1. ADOM mode must be enabled on FortiManager to work with FortiPortal. If needed, enable advanced adom-mode on FortiManager so that you can add VDOMs on the same physical device to different ADOMs.

   In the FortiManager CLI, run this command to enable ADOMs (and optionally set the ADOM mode to advanced):

   config system global
     set adom-status enable
     set adom-mode advanced
     y
   end

2. On FortiManager, create an admin user with read/write permission:

   config system admin user 
     edit <username>
       set profileid Super_User
       set adom all_adoms
       set policy-package all_policy_packages
       set password <password>
       set rpc-permit read-write
     next
   end

3. Enable workspace mode on FortiManager to work with FortiPortal:

   config system global
     set workspace-mode normal
   end

4. The SD-WAN monitoring widgets in the organization SD-WAN dashboard require that SD-WAN monitoring history is enabled to function properly. If this setting is not enabled, FortiManager only saves 10 minutes of SD-WAN data.

   To enable SD-WAN monitoring history on FortiManager:

   config system admin setting
     set sdwan-monitor-history enable
   end

5. Add your FortiManager device to FortiPortal. You must poll FortiManager to see the device list.

For more information about adding FortiManagers, see the FortiPortal Administration Guide.

To configure FortiAnalyzer to work with FortiPortal:

1. ADOM mode must be enabled on FortiAnalyzer to work with FortiPortal. You must enable the interface permission https on FortiAnalyzer for the portal-facing interface.
2. On FortiAnalyzer, create an admin user with read/write remote procedure calls enabled:

   config system admin user

   edit <user_name>

   set profileid Super_User

   set rpc-permit read-write

   end

For more information about adding FortiAnaliyzers, see FortiPortal Administration Guide.