Fortinet black logo

Administration Guide

Verifying VPN template and tunnel status

Verifying VPN template and tunnel status
To verify the template installation status:
  1. Go to Device Manager > Device & Groups. The list of Managed FortiGate devices is displayed.

  2. Verify that Config Status, Policy Package Status, and Provisioning Templates all display a green checkmark to indicate that the configuration is synchronized between FortiManager and FortiGate.

To verify the VPN tunnel status:
  1. Go to Device Manager > Monitors > VPN Monitor. A map displays.

  2. Enable Show Table to display the table of tunnels below the map.

  3. Verify that the Status is Up for each tunnel.

    Note

    The devices are missing in this image due to the WAN IP addresses used. Because they are not public addresses (TEST-NET-2 and TEST-NET-3 are used, see RFC 5737), FortiManager cannot place them on the map.

Verifying VPN template and tunnel status
To verify the template installation status:
  1. Go to Device Manager > Device & Groups. The list of Managed FortiGate devices is displayed.

  2. Verify that Config Status, Policy Package Status, and Provisioning Templates all display a green checkmark to indicate that the configuration is synchronized between FortiManager and FortiGate.

To verify the VPN tunnel status:
  1. Go to Device Manager > Monitors > VPN Monitor. A map displays.

  2. Enable Show Table to display the table of tunnels below the map.

  3. Verify that the Status is Up for each tunnel.

    Note

    The devices are missing in this image due to the WAN IP addresses used. Because they are not public addresses (TEST-NET-2 and TEST-NET-3 are used, see RFC 5737), FortiManager cannot place them on the map.