Fortinet black logo

FortiSwitch profiles

6.4.6
Copy Link
Copy Doc ID 0b20e530-d5de-11eb-97f7-00505692583a:933620
Download PDF

FortiSwitch profiles

If SD-WAN Orchestrator MEA prompts an exception when changing the profile of a device as reported in issue 064530, check if the two profiles meet the following conditions:

  1. Compare VLANs in interface FortiLink with these two profiles, and check if there are VLANs that own same VLAN ID.
  2. Compare VLANs in same interface (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name, but have different VLAN IDs.
  3. Compare VLANs in different interfaces (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name.

Workaround:

  1. Make sure the device is synchronized, and then enable the override device LAN setting.
  2. Disable Switch/AP configuration in Device LAN setting page.
  3. Wait 5-10 minutes until device’s configuration state becomes Modified, and then trigger a manual deployment.
  4. When device is synchronized, change profile.
  5. After changing the profile, disable override device LAN setting.

FortiSwitch profiles

If SD-WAN Orchestrator MEA prompts an exception when changing the profile of a device as reported in issue 064530, check if the two profiles meet the following conditions:

  1. Compare VLANs in interface FortiLink with these two profiles, and check if there are VLANs that own same VLAN ID.
  2. Compare VLANs in same interface (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name, but have different VLAN IDs.
  3. Compare VLANs in different interfaces (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name.

Workaround:

  1. Make sure the device is synchronized, and then enable the override device LAN setting.
  2. Disable Switch/AP configuration in Device LAN setting page.
  3. Wait 5-10 minutes until device’s configuration state becomes Modified, and then trigger a manual deployment.
  4. When device is synchronized, change profile.
  5. After changing the profile, disable override device LAN setting.