show

The show commands display a part of your unit’s configuration in the form of the commands that are required to achieve that configuration from the firmware’s default state.

Although not explicitly shown in this section, for all config commands, there are related show commands that display that part of the configuration. The show commands use the same syntax as their related config command.

CLI commands and variables are case sensitive.

Unlike the get command, show does not display settings that are in their default state.

Example

FMG-VM64 # show sys glob

config system global

set adom-status enable

set create-revision enable

set detect-unregistered-log-device disable

set device-view-mode tree

set hostname "FMG-VM64"

set policy-hit-count enable

end