System routing
Configuring routing settings
Use this procedure to configure routing settings for FortiIsolator.
Adding a static route
Use this procedure to add a static route.
Steps
- From the administration portal, go to Network > System Routing.
- To add a new static route, click Create New.
- Type the destination IP address and subnet mask in the Destination IP/Mask field.
- Type the gateway IP address in the Gateway field.
- In the Device drop-down list, select the interface for the static route.
- Click OK.
Editing a static route
Use this procedure to edit a static route.
Steps
- From the administration portal, go to Network > System Routing.
- To edit an existing static route, select the interface in the table, and click Edit.
- Type the destination IP address and subnet mask in the Destination IP/Mask field.
- Type the gateway IP address in the Gateway field.
- In the Device drop-down list, select the interface for the static route.
- Click OK.
Deleting a static route
Use this procedure to delete a static route.
Steps
- From the administration portal, go to Network > System Routing.
- To delete a static route, select the interface in the table, and click Delete.
Setting up system routing for Management IP
To set up system routing for Management IP from GUI:
- Go to Portal > Network > System Routing
- Fill out Destination IP/Mask, Gateway, and select mgmt. from Device dropdown.
-
Click OK to save it.
To set up system routing for Management IP from CLI:
> set mgmt-gw/<subnet> <gateway>
e.g.
> set mgmt-gw 0.0.0.0/0 192.168.1.254
Setting up system routing for Internal IP
To set up system routing for Internal IP from GUI:
- Go to Portal > Network > System Routing
- Fill out Destination IP/Mask, Gateway, and select Internal from Device dropdown.
-
Click OK to save it.
To set up system routing for Internal IP from CLI:
> set internal-gw/<subnet> <gateway>
e.g.
> set internal-gw 0.0.0.0/0 192.168.2.254
To setup system routing for External IP from GUI:
- Go to Portal > Network > System Routing
- Fill out Destination IP/Mask, Gateway, and select External from Device dropdown.
-
Click OK to save it.
To set up system routing for External IP from CLI:
> set external-gw/<subnet> <gateway>
e.g.
> set external-gw 0.0.0.0/0 192.168.3.254
To set up system routing for HA IP from GUI:
- Go to Portal > Network > System Routing
- Fill out Destination IP/Mask, Gateway, and select HA from Device dropdown.
-
Click OK to save it.
To set up system routing for HA IP from CLI:
> set ha-gw/<subnet> <gateway>
e.g.
> set ha-gw 0.0.0.0/0 192.168.4.254