Displaying NP7 HPE configuration and status information
You can use the following diagnose command to display NP7 HPE configuration and status information for one of the NP7 processors in your FortiGate.
diagnose npu np7 hpe 2
[NP7_2]
Queue Type NPU-min NPU-max CFG-min(pps) CFG-max(pps) Pkt-credit
0 high-priority39731 39731 40000 40000 0
0 TCP-syn 39731 39731 40000 40000 0
0 TCP-synack 39731 39731 40000 40000 0
0 TCP-finrst 39731 39731 40000 40000 0
0 TCP 39731 39731 40000 40000 0
0 UDP 39731 39731 40000 40000 0
0 ICMP 19865 19865 20000 20000 0
0 SCTP 19865 19865 20000 20000 0
0 ESP 19865 19865 20000 20000 0
0 IP-Frag 19865 19865 20000 20000 0
0 IP_others 19865 19865 20000 20000 0
0 ARP 19865 19865 20000 20000 0
0 l2_others 19865 19865 20000 20000 0
0 all-protocol 39731 39731 40000 40000 0
---------------------------------------------------------------------------
HPE HW pkt_credit:11080 , tsref_inv:50000, tsref_gap:32, hpe_refskip:0 , hif->nr_ring:40
Note:
NPU-min and NPU-max: The register reading of max and min value for each queue in NPU.
CFG-min(pps): the setting value of hpe configuration in CLI command and
it is packet per second rate limit for each host rx queue of NPU.
CFG-max(pps): The value is CFG-min of hpe configuration in CLI command.