Version:

Version:

Version:


Table of Contents

Hyperscale Firewall Guide

Download PDF
Copy Link

Enabling or disabling the NP7 VLAN lookup cache

You can use the following command to enable or disable VLAN lookup (SPV/TPV) caching for hyperscale firewall sessions.

config system npu

set vlan-lookup-cache {disable | enable}

end

This option is enabled by default.

Due to a known issue, with hyperscale firewall enabled, this option should be disabled if you configure more than 256 VLANs. Enabling or disabling vlan-lookup-cache requires a system restart. So you should only change this setting during a maintenance window.

Enabling or disabling the NP7 VLAN lookup cache

You can use the following command to enable or disable VLAN lookup (SPV/TPV) caching for hyperscale firewall sessions.

config system npu

set vlan-lookup-cache {disable | enable}

end

This option is enabled by default.

Due to a known issue, with hyperscale firewall enabled, this option should be disabled if you configure more than 256 VLANs. Enabling or disabling vlan-lookup-cache requires a system restart. So you should only change this setting during a maintenance window.