Hyperscale firewall for FortiOS 7.0.5 has the following limitations and incompatibilities with FortiOS features:
- Proxy or flow based inspection is not supported. You cannot include security profiles in hyperscale firewall policies.
- Single-sign-on authentication including FSSO and RSSO is not supported. Other types of authentication are supported.
- IPsec VPN is not supported. You cannot create hyperscale firewall policies where one of the interfaces is an IPsec VPN interface.
- Hyperscale firewall VDOMs do not support Central NAT.
- Hyperscale firewall VDOMs do not support profile-based NGFW firewall policies.
- Hyperscale firewall VDOMs do not support consolidated firewall policies.
Hyperscale firewall VDOMs must be NAT mode VDOMs. Hyperscale firewall features are not supported for transparent mode VDOMs.
Hyperscale firewall VDOMs do not support traffic shaping policies or profiles. Only outbandwidth traffic shaping is supported for hyperscale firewall VDOMs.
- Traffic shaping with queuing using the NP7 QTM module is not compatible with carrier-grade NAT and hyperscale firewall features. See NP7 traffic shaping.
Hyperscale firewall VDOMs do not support traffic that requires session helpers or ALGs (for example, FTP, TFTP, SIP, MGCP, H.323, PPTP, L2TP, ICMP Error/IP-options, PMAP, TNS, DCE-RPC, RAS, and RSH).
- Active-Active HA and FGSP do not support HA hardware session synchronization. Active-passive HA and virtual clustering do support HA hardware session synchronization.
- Asymmetric sessions are not supported.
- ECMP usage-based load balancing is not supported. Traffic is not directed to routes with lower spillover-thresholds.
- The Sessions dashboard widget does not display hyperscale firewall sessions.
- Interface device identification should not be enabled on interfaces that send or receive hyperscale firewall traffic.
proxyaction is not supported for DoS policy anomalies when your FortiGate is licensed for hyperscale firewall features. When you activate a hyperscale firewall license, the
proxyoption is removed from the CLI of both hyperscale VDOMs and normal VDOMs.
During normal operation, UDP sessions from protocols that use FortiOS session helpers are processed by the CPU. After an FGCP HA failover, when the UDP session helper sessions are re-established, they will not be identified as session helper sessions and instead will be offloaded to the NP7 processors.
When operating an FGCP HA cluster with session synchronization enabled, some of the sessions accepted by an IPv4 or a NAT64 hyperscale firewall policy with an overload IP pool may not be synchronized to the secondary FortiGate. Some sessions are not synchronized because of resource conflicts and retries. The session loss rate depends on the percentage of resource retries during session setup. You can reduce the session loss by making sure the IP pool has as many IP addresses and ports as possible.