SLA targets are a set of constraints that are used in SD-WAN rules to control the paths that traffic take.
The available constraints are:
- Latency threshold: Latency for SLA to make decision, in milliseconds (0 - 10000000, default = 5).
- Jitter threshold: Jitter for SLA to make decision, in milliseconds (0 - 10000000, default = 5).
- Packet loss threshold: Packet loss for SLA to make decision, in percentage (0 - 100, default = 0).
- On the FortiGate, add wan1 and wan2 as SD-WAN members, then add a policy and static route. See SD-WAN quick start for details.
- Go to Network > Performance SLA.
- Create a new Performance SLA or edit an existing one. See Link monitoring example.
- Enable SLA Targetsand configure the constraints.
To add multiple SLA targets, use the CLI.
- Configured the remaining settings as needed, then click OK.
config system sdwan config health-check edit "server" set server "126.96.36.199" set members 1 2 config sla edit 1 set link-cost-factor latency jitter packet-loss set latency-threshold 10 set jitter-threshold 10 set packetloss-threshold 1 next end next end end
link-cost-factor variable is used to select which constraints are enabled.