Fortinet black logo

Cookbook

Adding a static route

Copy Link
Copy Doc ID af0e75e9-211f-11ea-9384-00505692583a:626338
Download PDF

Adding a static route

After you create an SD-WAN interface, FortiGate adds a virtual interface for SD-WAN to the interface list that can be used to create routes.

You must configure a default route for the SD-WAN interface. The default gateways for each SD-WAN member interface do not need to be defined in the static routes table. FortiGate will decide which route or routes are preferred using Equal Cost Multi-Path (ECMP) based on distance and priority.

To create a static route for SD-WAN:
  1. Go to Network > Static Routes.
  2. Click Create New. The New Static Route page opens.
  3. Set Destination to Subnet, and leave the IP address and subnet mask as 0.0.0.0/0.0.0.0.
  4. From the Interface drop-down list, select SD-WAN.

  5. Ensure that Status is Enabled.
  6. Click OK to save your changes.

Next: Selecting the implicit SD-WAN algorithm

Adding a static route

After you create an SD-WAN interface, FortiGate adds a virtual interface for SD-WAN to the interface list that can be used to create routes.

You must configure a default route for the SD-WAN interface. The default gateways for each SD-WAN member interface do not need to be defined in the static routes table. FortiGate will decide which route or routes are preferred using Equal Cost Multi-Path (ECMP) based on distance and priority.

To create a static route for SD-WAN:
  1. Go to Network > Static Routes.
  2. Click Create New. The New Static Route page opens.
  3. Set Destination to Subnet, and leave the IP address and subnet mask as 0.0.0.0/0.0.0.0.
  4. From the Interface drop-down list, select SD-WAN.

  5. Ensure that Status is Enabled.
  6. Click OK to save your changes.

Next: Selecting the implicit SD-WAN algorithm