router multicast6
Use this command to configure the FortiGate unit as an IPv6 Protocol Independent Multicast (PIM) version 2 router.
Multicast routing is not supported in Transparent mode. |
config router multicast6 set multicast-routing {enable | disable} Enable/disable IPv6 multicast routing. set multicast-pmtu {enable | disable} Enable/disable PMTU for IPv6 multicast. config interface edit {name} # Protocol Independent Multicast (PIM) interfaces. set name {string} Interface name. size[15] - datasource(s): system.interface.name set hello-interval {integer} Interval between sending PIM hello messages (1 - 65535 sec, default = 30).. range[1-65535] set hello-holdtime {integer} Time before old neighbour information expires (1 - 65535 sec, default = 105). range[1-65535] next config pim-sm-global set register-rate-limit {integer} Limit of packets/sec per source registered through this RP (0 means unlimited). range[0-65535] config rp-address edit {id} # Statically configured RP addresses. set id {integer} ID of the entry. range[0-4294967295] set ip6-address {ipv6 address} RP router IPv6 address. next end
Additional information
The following section is for those options that require additional explanation.
config interface
Use this subcommand to configure the multicast6 interface.
hello-holdtime <seconds>
Specify the amount of time that a PIM neighbor may consider the information in a hello message to be valid (1 - 65 535 seconds, default = 105).
If the hello-interval
attribute is modified and the hello-holdtime
attribute has never been set explicitly, the hello-holdtime
attribute is automatically set to 3.5 x hello-interval
.
hello-interval <seconds>
Set the amount of time that the FortiGate unit waits between sending hello messages to neighboring PIM routers (1 - 65 535, default = 30).
Changing the hello-interval
attribute may automatically update the hello-holdtime
attribute .