system pppoe-interface
Use this command to configure the PPPoE interface. See the What's New for FortiOS 5.6 discussion of New PPPoE features for more information.
config system pppoe-interface edit {name} # Configure the PPPoE interfaces. set name {string} Name of the PPPoE interface. size[15] set dial-on-demand {enable | disable} Enable/disable dial on demand to dial the PPPoE interface when packets are routed to the PPPoE interface. set ipv6 {enable | disable} Enable/disable IPv6 Control Protocol (IPv6CP). set device {string} Name for the physical interface. size[15] - datasource(s): system.interface.name set username {string} User name. size[64] set password {password_string} Enter the password. size[128] set auth-type {option} PPP authentication type to use. auto Automatically choose the authentication method. pap PAP authentication. chap CHAP authentication. mschapv1 MS-CHAPv1 authentication. mschapv2 MS-CHAPv2 authentication. set ipunnumbered {ipv4 address} PPPoE unnumbered IP. set pppoe-unnumbered-negotiate {enable | disable} Enable/disable PPPoE unnumbered negotiation. set idle-timeout {integer} PPPoE auto disconnect after idle timeout (0-4294967295 sec). range[0-4294967295] set disc-retry-timeout {integer} PPPoE discovery init timeout value in (0-4294967295 sec). range[0-4294967295] set padt-retry-timeout {integer} PPPoE terminate timeout value in (0-4294967295 sec). range[0-4294967295] set service-name {string} PPPoE service name. size[63] set ac-name {string} PPPoE AC name. size[63] set lcp-echo-interval {integer} PPPoE LCP echo interval in (0-4294967295 sec, default = 5). range[0-4294967295] set lcp-max-echo-fails {integer} Maximum missed LCP echo messages before disconnect (0-4294967295, default = 3). range[0-4294967295] next end