system gre-tunnel
Use this command to configure a GRE Tunnel for your FortiGate, to allow remote transmission of data through Cisco devices that also have a GRE Tunnel configured.
History
The following table shows all newly added, changed, or removed entries as of FortiOS 6.0.
Command | Description |
---|---|
set ip-version {4 | 6} set remote-gw6 <addr6> set local-gw6 <addr6> |
Support for GRE tunnel termination using IPv6 addresses on both ends of the tunnel (in addition to the pre-existing IPv4 support). |
config system gre-tunnel edit {name} # Configure GRE tunnel. set name {string} Tunnel name. size[15] set interface {string} Interface name. size[15] - datasource(s): system.interface.name set ip-version {4 | 6} IP version to use for VPN interface. 4 Use IPv4 addressing for gateways. 6 Use IPv6 addressing for gateways. set remote-gw6 {ipv6 address} IPv6 address of the remote gateway. set local-gw6 {ipv6 address} IPv6 address of the local gateway. set remote-gw {ipv4 address} IP address of the remote gateway. set local-gw {ipv4 address any} IP address of the local gateway. set dscp-copying {disable | enable} Enable/disable DSCP copying. set keepalive-interval {integer} Keepalive message interval (0 - 32767, 0 = disabled). range[0-32767] set keepalive-failtimes {integer} Number of consecutive unreturned keepalive messages before a GRE connection is considered down (1 - 255). range[1-255] next end