switch-controller stp-settings

Use this command to configure global STP configuration for all managed FortiSwitches.

You can override the global STP settings for a FortiSwitch using the following commands:

config switch-controller managed-switch

edit <switch-id>

config stp-settings

set local-override enable

end

config switch-controller stp-settings
    set name {string}   Name of global STP settings configuration. size[31]
    set status {enable | disable}   Enable/disable STP.
    set revision {integer}   STP revision number (0 - 65535). range[0-65535]
    set hello-time {integer}   Period of time between successive STP frame Bridge Protocol Data Units (BPDUs) sent on a port (1 - 10 sec, default = 2). range[1-10]
    set forward-time {integer}   Period of time a port is in listening and learning state (4 - 30 sec, default = 15). range[4-30]
    set max-age {integer}   Maximum time before a bridge port saves its configuration BPDU information (6 - 40 sec, default = 20). range[6-40]
    set max-hops {integer}   Maximum number of hops between the root bridge and the furthest bridge (1- 40, default = 20). range[1-40]
    set pending-timer {integer}   Pending time (1 - 15 sec, default = 4). range[1-15]
end