Exempting an AP from rogue scanning
- Go to WiFi & Switch Controller > WIDS Profiles and create a new WIDS profile.
- Disable Enable Rogue AP Detection.
- Go to WiFi & Switch Controller > FortiAP Profiles and select the FortiAP profile.
Enable WIDS Profile and select that profile.
Rogue AP Monitor icons
The Rogue AP Monitor page uses the following icons:
|
Column |
Icon + Description |
|---|---|
| State |
 AP is detected but not yet classified.
|
| Status |
 AP is online and active.
|
| Signal Interference |
 AP signal interferes with a managed AP.
|
| On Wire |
AP is suspected rogue.
|
AP is accepted.
AP is marked as rogue, but unsuppressed.
AP is marked as rogue, but suppressed.
AP is inactive.
AP signal interference ranges from low (green) to high (red), measured in dBm.