Configuring the SDN Connector
The SDN Connector GUI has several web controls. It is a single-page web application.
To restart the service, click Restart Service. The system displays a dialog asking you to restart the connector service.
To change the password, click Change Password.
To change the configuration click Configuration.
The Configuration page consists of the following fields:
|
Field |
Description |
|---|---|
|
APIC Host/IP |
You can enter multiple APIC IP addresses and/or fully qualified domain names. Ensure that you separate each entry with a comma. |
|
APIC Username |
Enter the Cisco ACI username as obtained from the ACI administrator. |
|
APIC Password |
Enter the Cisco ACI password as obtained from the ACI administrator. |
|
Fabric Connector Username |
Enter the FortiGate/FortiManager username used to log into the Fortinet SDN connector. The default username is admin. |
|
Change Fabric Connector Password |
Enter the FortiGate/FortiManager password used to log into the Fortinet SDN connector. The default password is fortinet123. |
To upgrade the service, go to the SDN Connector homepage, then click UpgradeService on the banner. A dialog shows the upgrade progress. Once the upgrade finishes, the dialog prompts “Upgraded Successfully! Going to refresh in 10s” and the GUI refreshes automatically. This allows patch upgrade for SDN Connector.
The following displays sample output objects pulled from Cisco ACI:
Click Running Status to verify the status. When the signal icons are green, this indicates the connection between the SDN controller and SDN connector has been established.