Hot swapping an AC PSU
Follow these steps to safely hot swap an AC PSU.
You can hot swap a PSU without affecting performance or interrupting traffic as long as one PSU remains connected to power at all times. |
- Attach an ESD wrist strap to your wrist and to an ESD socket or to a bare metal surface on the chassis or frame.
- Turn off the power being supplied to the PSU and disconnect the power cord.
- Press the latch towards the handle until the PSU is detached then pull it out of the FortiGate 6000F.
- Insert a replacement PSU into the FortiGate 6000F and slide it in until it locks into place.
- Use a supplied C15 power cable to connect power to the PSU C16 power connector.
- Turn on power to the PSU.
- Verify that the PSU status LED is solid green meaning that the PSU is powered up and operating normally.