Primary FortiGate 6000F selection with override disabled (default)

FortiGate 6000F FGCP selects the primary FortiGate 6000F based on standard FGCP primary unit selection and also accounting for the number of failed FPCs. The selection sequence is:

• At least one active FPC
• Connected monitored interfaces
• Number of active FPCs
• Number of active SSDs (if SSD failure protection is enabled, FortiGate 6001Fs, FortiGate 6301Fs, or FortiGate 6501Fs, only)
• Age
• Device priority
• Serial number

In most cases and with default settings, if everything is connected and operating normally, the FortiGate-6000 with the highest serial number becomes the primary FortiGate-6000. You can set the device priority higher on one of the FortiGate-6000s if you want it to become the primary FortiGate-6000.

The selection sequence also shows that at least one FPC must be active for a FortiGate 6000F to be selected to be the primary. If at least one FPC is active on each FortiGate 6000F, the most important criteria is the number of connected monitored interfaces followed by the number of failed FPCs, followed by the number of active SSDs if SSD failure protection is enabled. So if one or more FPCs fail, if interface monitoring is not configured or no monitored interface has become disconnected, the primary FortiGate 6000F will be the one with the most active FPCs.