FortiGate-6000 supports the FortiGate Session Life Support Protocol (FGSP) (also called standalone session sync) to synchronize sessions among up to four FortiGate-6000s. FortiGate-6000 also supports FGSP between FGCP clusters.
For details about FGSP, see: FGSP.
FortiGate-6000 FGSP support has the following limitations:
- FortiGate-6000 FGSP can use either the HA1 or the HA2 interface (but not both) for session synchronization. To use one these interfaces for session synchronization, you must give it an IP address and optionally set up routing for the interface as required. Ideally the session synchronization interface of each FortiGate-6000 would be on the same network and that network would only be used for session synchronization traffic. However, you can configure routing to send session synchronization traffic between networks. NAT between session synchronization interfaces is not supported.
- You can't use data interfaces for FGSP session synchronization.
- If you encounter performance issues because of the HA1/HA2 bandwidth limit of 10 Gbps, you can create a LAG consisting of the HA1 and HA2 interfaces to increase the bandwidth capacity to 20 Gbps. See Creating an HA1/HA2 LAG for FGSP session synchronization .
- You can use configuration synchronization to synchronize the configurations of the FortiGate-6000s in the FGSP deployment (see Standalone configuration synchronization). You can use the HA1 and HA2 interfaces for configuration synchronization. You can also configure the FortiGate-6000s separately or use FortiManager to keep key parts of the configuration, such as security policies, synchronized.
- FortiGate-6000 FGSP doesn't support setting up IPv6 session filters using the
- Asymmetric IPv6 SCTP traffic sessions are not supported. These sessions are dropped.
- Inter-cluster session synchronization, or FGSP between FGCP clusters, is supported, see Synchronizing sessions between FGCP clusters.
- FGSP IPsec tunnel synchronization is not supported.
- Fragmented packet synchronization is not supported.