Before verifying normal operation and making configuration changes and so on you should wait until the FortiGate-6000 is completely started up and synchronized. This can take a few minutes.
To confirm that the FortiGate-6000F is synchronized, view the Security Fabric dashboard widget. If the system is synchronized, the management board and all of the FPCs should be visible and FortiGate telemetry status should be Connected. The widget also indicates if any FPCs are not synchronized. You can also view the Sensor Information widget to confirm that the system temperatures are normal and that all power supplies and fans are operating normally.
From the CLI you can use the
diagnose sys confsync status | grep in_sy command to view the synchronization status of the management board and FPCs. If all of the FPCs are synchronized, each output line should include
in_sync=1. If a line ends with
in_sync=0, that FPC is not synchronized. The following example just shows a few output lines:
diagnose sys confsync status | grep in_sy FPC6KF3E17900200, Slave, uptime=5385.45, priority=119, slot_id=2:1, idx=2, flag=0x4, in_sync=1 F6KF313E17900031, Slave, uptime=5484.74, priority=2, slot_id=1:0, idx=0, flag=0x10, in_sync=1 F6KF313E17900032, Master, uptime=5488.57, priority=1, slot_id=2:0, idx=1, flag=0x10, in_sync=1 FPC6KF3E17900201, Slave, uptime=5388.78, priority=120, slot_id=2:2, idx=2, flag=0x4, in_sync=1 F6KF313E17900031, Slave, uptime=5484.74, priority=2, slot_id=1:0, idx=0, flag=0x10, in_sync=1 ...