FortiLink support

FortiGate-6000 supports managing FortiSwitch devices over FortiLink. You can manage up to 300 FortiSwitch devices from one FortiGate-6000.

Use the following command to enable Fortilink support on the GUI and in the CLI:

config system global

set switch-controller enable

end

Managed FortiSwitch GUI pages appear under the WiFi & Switch Controller GUI menu.

A FortiGate-6000 manages one or more FortiSwitches through one active FortiLink. The FortiLink can consist of one physical interface or multiple physical interfaces in a LAG. To set up a FortiGate-6000 interface as a FortiLink, from the GUI go to Network > Interface, select an interface, and set the Addressing mode to Dedicated to FortiSwitch.

You can also use the following CLI command to set the port7 interface of a FortiGate-6000 device to be the FortiLink:

config system interface

edit port7

set auto-auth-extension-device enable

set fortilink enable

end

end

You can use any traffic interface as the FortiLink. Using the HA and management interfaces is not supported.

For limitations on FortiLink support, see FortiLink support.

For more information about FortiLink support and managing FortiSwitches, see FortiSwitch devices managed by FortiOS.