Fortinet Document Library
Version:
7.2.0
7.0.3
7.0.2
Version:
7.0.1
Table of Contents
Introduction
Supported hardware models
Getting started
Check current manage mode
Main LTE/5G features
Cellular capabilities
Supported wireless carriers
SIM mapping
Add a data plan and APN
Global SIM with roaming on
SIM-switch
SIM switch-back
Get modem status
Stopping data traffic on overaged LTE interface
OBM management
Modes of operation
IP pass-through mode
NAT mode
Interface management
Interface configuration guideline
Access allowance
Get interface status
Configure LAN switch
Configure switch interface
Configure VXLAN interface
Aggregate interface support with load-balancing
Configure a private network
DHCP configurations
Configure DHCP server
Configure DHCP relay
Network utilities
Address
Service
Target
System routing
Configure static routing
Configure dynamic routing — OSPF
Configure OSPF from Console (CLI)
Configure OSPF status
Configure OSPF router-id
Configure OSPF area
Configure OSPF network
Configure OSPF interface
Configure OSPF redistribution
Verify OSPF configurations
Verify OSPF status
Verify OSPF interface
Verify OSPF neighbor adjacency
Verify OSPF database
Verify OSPF routes
Verify routing table
Configure OSPF GUI
Complete OSPF configuration code example
Configure PBR routing
View routing configurations
Move PBR rules
Configure multicast routing
Firewall
Configure address/subnet
Configure protocol/port range
Configure firewall policies
Move firewall policies
VPN
Configure VPN
Check VPN tunnel status
IPsec VPN support for third-party certificates
DNS Service
Enable DNS service
Set up DNS database
SD-WAN
Configure an SD-WAN
Check SD-WAN health
Define an SD-WAN member
Health monitoring
Monitor interface status
Perform link health check
Configure health monitoring
System management
Add trusted hosts
Activate the default admin account
Multiple static access controller addresses or FQDN
Get system version
Get user session status and force log-out
Upgrade OS firmware
Upgrade modem firmware
SMS notification
Remote diagnostics via SMS
Export system logs to remote syslog servers
Support for SNMP (read-only) and traps
Get MIB2 interface statistics via SNMP
Dual modems
Dual modems in NAT mode
Troubleshooting, diagnostics, and debugging
Troubleshooting
Status, diagnostics, and debugging commands
Diagnose from Telnet
Collect complete diagnostics information
Appendix A: Configure LTE settings
Add a new carrier profile
Add a new operator/carrier
Create a data plan
Activate a SIM card
Configure start session timeout
Check the recorded SIM card IMSI number
Delete the recorded SIM card IMSI number
Set the default SIM
Enable SIM-switch
Dual modems
Dual-modem in IP pass-through mode
Dual modems in NAT mode
Change Log
Home
FortiExtender 7.2.0
Admin Guide (Standalone)
Admin Guide (Standalone)
Introduction
Supported hardware models
Getting started
Check current manage mode
Main LTE/5G features
Cellular capabilities
Supported wireless carriers
SIM mapping
Add a data plan and APN
Global SIM with roaming on
SIM-switch
SIM switch-back
Get modem status
Stopping data traffic on overaged LTE interface
OBM management
Modes of operation
IP pass-through mode
NAT mode
Interface management
Interface configuration guideline
Access allowance
Get interface status
Configure LAN switch
Configure switch interface
Configure VXLAN interface
Aggregate interface support with load-balancing
Configure a private network
DHCP configurations
Configure DHCP server
Configure DHCP relay
Network utilities
Address
Service
Target
System routing
Configure static routing
Configure dynamic routing — OSPF
Configure OSPF from Console (CLI)
Configure OSPF status
Configure OSPF router-id
Configure OSPF area
Configure OSPF network
Configure OSPF interface
Configure OSPF redistribution
Verify OSPF configurations
Verify OSPF status
Verify OSPF interface
Verify OSPF neighbor adjacency
Verify OSPF database
Verify OSPF routes
Verify routing table
Configure OSPF GUI
Complete OSPF configuration code example
Configure PBR routing
View routing configurations
Move PBR rules
Configure multicast routing
Firewall
Configure address/subnet
Configure protocol/port range
Configure firewall policies
Move firewall policies
VPN
Configure VPN
Check VPN tunnel status
IPsec VPN support for third-party certificates
DNS Service
Enable DNS service
Set up DNS database
SD-WAN
Configure an SD-WAN
Check SD-WAN health
Define an SD-WAN member
Health monitoring
Monitor interface status
Perform link health check
Configure health monitoring
System management
Add trusted hosts
Activate the default admin account
Multiple static access controller addresses or FQDN
Get system version
Get user session status and force log-out
Upgrade OS firmware
Upgrade modem firmware
SMS notification
Remote diagnostics via SMS
Export system logs to remote syslog servers
Support for SNMP (read-only) and traps
Get MIB2 interface statistics via SNMP
Dual modems
Dual modems in NAT mode
Troubleshooting, diagnostics, and debugging
Troubleshooting
Status, diagnostics, and debugging commands
Diagnose from Telnet
Collect complete diagnostics information
Appendix A: Configure LTE settings
Add a new carrier profile
Add a new operator/carrier
Create a data plan
Activate a SIM card
Configure start session timeout
Check the recorded SIM card IMSI number
Delete the recorded SIM card IMSI number
Set the default SIM
Enable SIM-switch
Dual modems
Dual-modem in IP pass-through mode
Dual modems in NAT mode
Change Log
7.2.0
7.2.0
7.0.3
7.0.2
7.0.1
Download PDF
Copy Link
System management
This section discusses system management tasks. It covers the following topics:
Get system version
Upgrade OS firmware
Upgrade modem firmware
SMS notification
Remote diagnostics via SMS
Export system logs to remote syslog servers
Support for SNMP (read-only) and traps
System management
System management
This section discusses system management tasks. It covers the following topics:
Get system version
Upgrade OS firmware
Upgrade modem firmware
SMS notification
Remote diagnostics via SMS
Export system logs to remote syslog servers
Support for SNMP (read-only) and traps
Link
PDF
TOC
