VLAN mode
CAPWAP mode do not perform well as desired on low-end FortiGate devices. VLAN mode has been introduced to improve performance. FortiExtender in VLAN mode is also managed by FortiGate in the same way as CAPWAP mode, but it uses VLAN to forward traffic between FortiGate and FortiExtender.
Configurations on FortiExtender
The VLAN interface is created automatically on FortiExtender. You cannot edit it or remove it.
FX212E5919000009 # config system interface FX212E5919000009 (interface) # edit vlan1 FX212E5919000009 (vlan1) # show edit vlan1 set type vlan set vid 100 set ingress-intf lan next FX212E5919000009 (vlan1) # next FX212E5919000009 (interface) # edit vlan2 FX212E5919000009 (vlan2) # show edit vlan2 set type vlan set vid 200 set ingress-intf lan next FX212E5919000009 (vlan2)
Virtual Wire Pair
Just like CAPWAP mode, Virtual Wire Pair Configurations of the virtual wire pair are created automatically. You cannot edit it or remove it. These configurations specify the mapping of the LTE interfaces and the VLAN interfaces.
FX212E5919000009 (virtual-wire-pair) # show
config system virtual-wire-pair
set lte1-mapping vlan1
set lte2-mapping vlan2
end
FX212E5919000009 (virtual-wire-pair) #