Fortinet Document Library

Version:

Version:

Version:

Version:

Version:

Version:


Table of Contents

Administration Guide

Connect to the GUI

Use the GUI to configure and manage FortiDeceptor.

To connect to the FortiDeceptor GUI:
  1. Connect the port1 (administration) interface of the device to a management computer using an Ethernet cable.
  2. Configure the management computer to be on the same subnet as the internal interface of the FortiDeceptor unit:
    • Change the IP address of the management computer to 192.168.0.2.
    • Change the IP address of the network mask to 255.255.255.0.
  3. Go to https://192.168.0.99.
  4. Type admin in the Name field, leave the Password field blank, and click Login.

    You can now proceed with configuring your FortiDeceptor unit.

If the network interfaces have been configured differently during installation, the URL and administrative access protocols might not be in their default state.

Connect to the GUI

Use the GUI to configure and manage FortiDeceptor.

To connect to the FortiDeceptor GUI:
  1. Connect the port1 (administration) interface of the device to a management computer using an Ethernet cable.
  2. Configure the management computer to be on the same subnet as the internal interface of the FortiDeceptor unit:
    • Change the IP address of the management computer to 192.168.0.2.
    • Change the IP address of the network mask to 255.255.255.0.
  3. Go to https://192.168.0.99.
  4. Type admin in the Name field, leave the Password field blank, and click Login.

    You can now proceed with configuring your FortiDeceptor unit.

If the network interfaces have been configured differently during installation, the URL and administrative access protocols might not be in their default state.